Adjustment knob to properly adjust the helmet to your head. Ventilation channels inside the helmet with an outlet at the back. 470 g in size M (In-Mold/ABS hybrid construction).
Complies with the EN 1077:2007 standard cat. Foam padded and ventilated liner hat.
Liner hat that is removable and machine washable at 30°C. The upper part of the FR 500 ski helmet is in ABS (resistance), and the lower part in In-Mold (low weight). The ABS construction (rigid shell) is a little heavier but increases the protection against penetration branch, stones, etc. The In-Mold construction has an outer polycarbonate shell that is moulded directly onto the EPS shell.
The inner EPS liner absorbs shocks in the event of a collision. The whole thing is extremely lightweight. The adjustment wheel plays a key role in keeping your helmet secure. This system can be easily and precisely adjusted at any time using the easily accessible dial that you can even use with your skiing gloves.This makes it comfortable to use and provides maximum safety. Turn the dial to the right to tighten and to the left to loosen. Standard EN 1077:2007 is a European standard that applies to helmets used for cranial protection during downhill skiing and snowboarding. This standard tests the ability to absorb shocks and resistance to penetration. Class A: protects the top and back of the head, as well as the ears and the side of the head. Class B: Protects the top and back of the head but doesn't cover the ears. Measure your head's circumference in centimetres (around the middle of the forehead and just above the ears). Choose the size that covers this measurement. Example: if you have a head circumference of 56 cm, you should try a helmet in size 55-59 cm.
Take plenty of time to try it on properly. You shouldn't feel any areas of discomfort.If you do then try another model. Always try your helmet with your mask, because not all helmets go with all masks.
A helmet is compatible with a ski mask when there is no air space between the top of the mask and the helmet. During practice, the ski helmet must be properly fitted and adjusted. It is essential to choose the right size.The head circumference must be adjusted using the thumb wheel. The chinstrap must be properly adjusted.
It's a bit like the seat belt in a car: if it's too loose, it will not perform its function and you will be less protected. Avoid putting a thick hat under your helmet as this will move the helmet away from your head and you won't be as well protected.Opt instead for a very thin beanie or balaclava that does not affect your safety. A helmet has good insulating properties. There is often no point in adding anything else. Also, avoid adding a camera to your helmet as this can affect safety. The standard does not take into account any elements added to the helmet. Removable and machine washable liner hat and ears at 30°C. Use only soapy water and a soft cloth to clean your helmet. Boom 100% Expanded Polystyrene Racket T joint 50% Acrylonitrile Butadiene Styrene, 50% Polycarbonate Bottom bracket 100% Polyurethane.
Do not store in a damp place, near a source of heat or UV rays. Dry before storing, preferably in a fabric helmet bag. Replace any helmet that has sustained an impact.This item is in the category "Sporting Goods\Skateboarding\Protective Gear". The seller is "freness" and is located in this country: GB. This item can be shipped to all countries in Europe.